What do I do if my Honeywell Thermostat is not working? After 5 seconds, reinsert them the right way. To reset your Honeywell Thermostat, switch it off, remove the batteries, and put them back in reverse polarity: negative terminals facing positive. This should put the thermostat in a manual mode. Release all depressed buttons at the same time. While still holding the display button, quickly press the up arrow button. Keep the display button depressed and let go of the off button. How do I manually override my Honeywell thermostat? The compressor is responsible for circulating the refrigerant through your unit and helping it to cool down the air that enters your home. Most commonly, this is done to protect the HVAC system compressor. The Honeywell thermostat system says wait on cool when it is prolonging an activation of your HVAC system. If the system is working properly, then “Wait” should disappear after a few minutes. This is done to prevent damaging the HVAC system compressor. ![]() The “Wait” message on a Honeywell Thermostat means the thermostat is waiting to activate the HVAC system.
0 Comments
Leave a Reply. |